l have already checked fuses and changed my headlamp switch and stillno luck, l also have no power at the socket.
hey everyone that responded to my problem thank you very much l was able to trace problem all the way back to the dimmer switch on stearing wheel, couple of corroded wires

Did you check the fuse with your circuit tester? Not just look at it, but actually use a 12 volt test lamp? Did you get a light on both sides of the fuse? If so, the fuse is good.

Now go to the switch. Do you have 12 volts going in? How about coming out? Sometimes even new switches are bad.

If you have voltage there, but not at the socket, there is a bad wire between the two points.

If only one side is not working then u have a loose/break in the wire going to that bulb. You will need to trace the wiring from the socket to find the problem. It could be anywhere.

If both head lights r not working then u need to check supply power. Double check the fuse. Then pull ur new headlight switch out & verify that it is working correctly (continuity check).

Do ur high beams work? If ur highs work but not ur lows (or lows but not highs) then that would point to ur high beam switch being the culprit.

The headlights r not individually fused per side.

You need to do a little digging to find where the problem is. A little more info on the problem would also help us; only one side or both sides not working, only low or high beams, do ur other exterior lights work?

change the headlight bulbs

look for a bad ground. bob